Vol. 22 No. 5 (2023): May 2023

COPEN-12:2022

Proceedings of the International Conference on Precision, Micro, Meso, and Nano Engineering

Volume 5: Non-traditional machining processes

Published: 01-05-2023

Articles

Investigation into energy interaction behavior of nitinol SMA during WECM

Naresh Besekar, B. Bhattacharyya

1-6
- pdf
On the performance analysis of micro-hole drilling using magnetic field-assisted electrochemical spark machining

Roopa Singh, D. K. Singh, Jeeoot Singh

7-12
- pdf
Effect of step pulse waveform in electrochemical micromachining for dimension control

Himadri Sekhar Panda, B. Bhattacharyya

13-17
- pdf
On electrochemical discharge milling of glass with horizontal tool and vertically upward feeding technique

Sudip Santra, Biplab Ranjan Sarkar, Biswanath Doloi, Bijoy Bhattacharyya

18-23
- pdf
Jet pressure influence on micro-abrasive waterjet trepanned hole in CFRP composite material

Rajesh Ranjan Ravi, D. S. Srinivasu

24-29
- pdf
Hybrid strategy for enhancing the dimensional accuracy and surface finish of abrasive waterjet milled pockets

Chinmoyee Datta, D. S. Srinivasu

30-35
- pdf
Understanding and predicting material removal rate in abrasive waterjet milling of kerfs

T. N. Deepu Kumar, D. S. Srinivasu

36-43
- pdf
Characterization of microwave-drilled holes in kenaf-reinforced epoxy composites

Rampal, Sunny Zafar

44-49
- pdf
Operational feasibility of Maglev EDM using powder mixed dielectric for machining Ti-grade 5 alloy

Rajesh Sahoo, Vivek Bajpai, Nirmal Kumar Singh

50-55
- pdf
FEM modeling for predicting temperature profile of heat affected zone in single spark EDM process

S.C. Sonthalia, Gaurav Bartarya, S. Mullick

56-62
- pdf
Experimental investigation on the stability of electro chemical discharge machining (ECDM)

Dil Bahar, Akshay Dvivedi, Pradeep Kumar

63-70
- pdf