Vol. 18 No. 3 (2019): March 2019

Articles

• Design of special fixture for hard chromium plating on internal surface of hollow cylinder open at one end and with restricted opening at the other end with L/D ratio more than 4

  S. S. Avadhani, Champuri Srinivas Rao, C. J. Kumara

  4-9

  • pdf

• Review on design guidelines for selective laser melting

  B. N. Manjunath, Prafullakumar Chaudhari, Hemant Pawar, S. K. Verma, S. S. Anasane

  10-18

  • pdf

• Calibration of co-ordinate measuring machine by self tracking laser interferometer (Laser Tracer)

  H. S. Chethan, Rama Mohan, C. T. Shivaraju

  19-24

  • pdf

• Investigation on the effect of nucleation time on CNT growth process using RF-PECVD

  K. Ankit , K. Niranjan Reddy, Gokul, N. Balashanmugam

  25-30

  • pdf

• Piezo-resistive mems pressure sensor for tire bead seating pressure measurement design, simulation, analysis and fabrication process

  N. Kusuma , E. S. Sujit

  31-38

  • pdf

• Mechanical and structural characterization of dlc prepared by PECVD technique

  Champuri Srinivas Rao, Leo Prakash

  39-41

  • pdf

• Study on the influence of spindle running accuracy and feed drive characteristics of a diamond turning machine on work piece accuracy

  Prakash Vinod

  42-46

  • pdf

• Mathematical modeling of spindle deflection for multi spindle automat and validation using ansys software

  G. S. Pramod Krishna, Tom Saju

  47-53

  • pdf

• Challenges and research opportunities in metal additive manufacturing

  B. N. Manjunath, A. R. Vinod, S. K. Verma, N. Balashanmugam

  54-57

  • pdf

• Effect of excimer laser parameters on the ablation depth during micromachining of polycarbonate

  E. Pradeep Kumar Reddy , Sunil Magadum

  58-61

  • pdf

• Functional evaluation of copper in conventional wire bonding as compared to gold

  S. Harsha, S. Mahalakshmi , Alexander George

  62-67

  • pdf