Experimental and finite element analysis of alloy wheel in static condition
Keywords:
Aluminum Alloy Wheel, AL Alloy 201.0-T43, Static Analysis, Impact Load, Strain Gauge, FEA, ANSYSAbstract
Wheel is important component of any vehicle. Vehicle can run if there is no engine but it cannot run without wheel on road. In power transmission system of vehicle, wheel last element. Wheel is a mechanical device which bear and transfer whole mass of vehicle to road. Wheel is one of the prime components of transporting system hence its analysis is a measure concern. Finding and locating the true compressive stresses is an important and key step in accurate design of the wheel. Because of compressive load Alloy wheel bend and failure usually occurs due to fracture. The present work has been intended for compressive stress analysis at critical section of alloy wheel under static state by different methods. Theoretical analysis has been done using theoretical formulae but it is necessary to carry out experimental analysis of alloy wheel in static condition for better understanding of failure. In order to have a best and reliable design of alloy wheel it is necessary to determine these stresses developed in the alloy wheel. For exact evaluation of failure pattern it is necessary to carry out experimental and finite element analysis of alloy wheel. The paper deals with experimental and finite element analysis of Alloy Wheel. Amount of load coming on wheel is measured and applied on Alloy-wheel by UTM with help of fixture for experimental analysis and by ANSYS for FEA analysis. The wheel is tested for Impact load. The strain gauge along with UTM Machine was used for determining stress at critical section. ANSYS software used for finite element analysis under static state. Accurate Stress coming on front wheel of bike at load and no load condition are calculated. The results obtained from finite element analysis methods were compared with the results of experimental analysis. The results show that the stress calculated by experimental method closer to true value in static state and stress concentration due to load is maximum at intersection area between spoke and rim. It has great scope for further modification in design for stress and failure analysis.
Metrics
Downloads
Published
How to Cite
Issue
Section
License
All the articles published in Manufacturing Technology Today (MTT) Journal are held by the Publisher. Central Manufacturing Technology Institute (CMTI) as a publisher requires its authors to transfer the copyright prior to publication. This will permit CMTI to reproduce, publish, distribute, and archive the article in print and electronic form and also to defend against any improper use of the article.